- 25 motor faders (24 channels + 1 master)
- 48 input mixing channels (40 mono + 2 stereo + 2 return)
- 20 Aux (8 mono + 6 stereo) + Stereo + Sub buses
- 8 DCA groups with Roll-out
- 24 analog XLR/TRS combo mic/line inputs + 2 analog RCA pin stereo line inputs
- 16 analog XLR outputs
- 34 x 34 digital record/playback channels via USB 2.0 + 2 x 2 via a USB storage device
- 1 expansion slot for NY64-D audio interface card
Outline
Fader Configuration | 24 + 1 (Master) | |
---|---|---|
Mixing Capacity | Input Channels | 48 (40 mono + 2 stereo + 2 return) |
Aux Buses | 20 (8 mono + 6 stereo) | |
Stereo Buses | 1 | |
Sub Buses | 1 | |
Input channel functions | 8 DCA Groups | |
I/O | Inputs | 24 mic/line (XLR/TRS combo) + 2 stereo line (RCA pin) |
Outputs | 16 (XLR) | |
Expansion slots | 1 | |
On-board processors | DSP | 8 Effects + 10 GEQ |
USB | 34x34 USB Audio Interface, 2-track recording via USB Storage Device |
General specifications
Sampling frequency rate | Internal | 48 kHz |
---|---|---|
Signal delay | Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz | |
Fader | 100 mm motorized, Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders | |
Total harmonic distortion | Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz) | |
Frequency response | +0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT | |
Dynamic range | 110 dB typ., DA Converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min. | |
Hum & noise level | Equivalent input noise | –128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter) |
Residual output noise | –85 dBu, ST master off (Measured with an A-Weight filter) | |
Crosstalk | –100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min. | |
Power requirements | 100–240 V 50/60 Hz | |
Power consumption | 110 W | |
Dimensions | W | 716 mm (28.2in) |
H | 225 mm (8.9in) | |
D | 599 mm (23.6in) | |
Net weight | 17.0 kg (37.5lb) | |
Accessories | Quick Guide, Power Cord, CUBASE AI download information | |
Options | Expansion Card, Foot Switch (FC5) | |
Others | Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C |
Analog input characteristics
Input Terminals | GAIN | Load Impedance |
For Use With Nominal |
Input Level | Connector | balanced / Unbalanced |
||
---|---|---|---|---|---|---|---|---|
Sensitivity*1 | Nominal | Max. before clip | ||||||
INPUT1-24 | +66dB | 7.5KΩ | 50-600Ω Mics or 600Ω Lines |
-82dBu (61.6V) | -62dBu (0.616mV) | -42dBu (6.16mV) | Combo Jack (XLR-3-31 type *2 or TRS phone *3) |
Balanced |
-6dB | -10dBu (245mV) | +10dBu (2.45V) | +30dBu (24.5V) | |||||
ST IN 1,2 | — | 10kΩ | 600Ω Lines | -30dBV (31.6V) | -10dBV (316mV) | +10dBV (3.16V) | RCA Pin Jack | Unbalanced |
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
Output Terminals | Source Impedance |
For Use With Nominal |
GAIN SW | Output Level | Connector | balanced / Unbalanced |
|
---|---|---|---|---|---|---|---|
Nominal | Max. before clip | ||||||
OMNI OUT 1-16 | 75Ω | 600Ω Lines | “+24dBu” position (default) |
+4dBu (1.23 V) | +24dBu (12.3 V) | XLR-3-32 type *1 | Balanced |
PHONES *3 | 100Ω | 40Ω Phones | — | 3mW | 75mW | Stereo Phone Jack (TRS) *2 | Unbalanced |
*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.
Digital input/output specifications
Terminals | Format | Data length | Audio | Connector |
---|---|---|---|---|
USB (TO HOST) | USB | 24bit | 34ch input / 34ch output, PCM | USB (B type) |
iPad | USB | — | Playback: MP3 or WAV file data / Record: WAV file data | USB (A type) |
Control I/O specifications
Terminals | Format | Level | Connector |
---|---|---|---|
NETWORK | IEEE802.3 | 10BASE-T/100Base-TX | RJ-45 |
FOOT SW | — | — | TS Phone |
Related Products
Yamaha TF5
High input capacity and fader count makes this powerful console ideal for larger applications. ..
258,000.00 МКД
Yamaha CL3
An ideal blend of compact size and channel capacity for a variety of live and installed applications..
1,337,270.00 МКД
Yamaha QL5
32 + 2 fader configuration adapts to a wide range of channel layouts. The QL5 is a compact console w..
826,000.00 МКД 1,032,600.00 МКД
Yamaha TF1
Compact, portable, and even rack mountable, the TF1 offers impressive capability and versatility for..
160,000.00 МКД 184,500.00 МКД
Tags: Yamaha TF3